How to install hot and cold water faucets

Hot and cold water faucets play a very important role in our home life, many families install hot and cold water faucets in kitchens and bathrooms so that we can use hot and cold water freely, however, everyone knows that installing hot and cold water faucets is not a very simple thing, if you want to install it, you need to know some basic installation knowledge in advance, if you want to install your own hot water faucet, you can follow the Luban home furniture installation master introduction.

(1) Tools for installing hot and cold water faucets:

Before the equipment, we prepared the tools that may be used, the general tools are: wrench, waterproof tape; Remember to check whether the hot and cold water faucet parts are complete, the common faucet parts are: hose, shower, rubber gaskets, kidnappers, water removal, decorative caps, etc.

(2) Bathing device with hot and cold water faucet:

Use hot and cold water faucets when bathing, when installing equipment, you should check which side is cold water, which side is hot water, generally the left side is connected to hot water, the right side is connected to cold water, for the future, use waterproof tape to wrap the connector several times to avoid water leakage, and then tighten the faucet on the connector, tighten it with a wrench, turn the switch to check the direction of cold and hot water and the water flow is normal, there is no leakage, the shower should also be adjusted according to the height, now the vertical handheld shower used now, the height is generally 2050-2200mm; The ceiling active shower height is generally 2100-2300mm.

(3) Install hot and cold water faucets in the sink:

Nowadays, many people in the kitchen sink will also be equipped with hot and cold water faucets to prevent washing vegetables and hurting their hands in winter, the hot and cold water faucet device of the sink is relatively simple, usually, there are two hoses, let's put the copper buckle and rubber pad into the two hoses, then take one of the two pipes from the sink, put it in the hole, then put the rubber pad in the hose and put the wire in it, then take the faucet and screw the pipe to the faucet, the copper wire should also be tightened, and finally, put it into the hole of the sink, Tighten it with the internal copper buckle to hold the faucet smoothly, then connect the two pipes to the outlet, remember to determine which pipe the hot and cold water is or inconvenient to use in the future.